How to use a deep well pump (deep water pump)?

Many customers will encounter some technical problems when choosing a deep well pump (deep water pump), such as the height of the deep well pump (deep water pump) and what kind of state he can reach, will it rust, how to Maintenance and other issues. To solve some of the above questions, let us first understand the principle of the deep well pump (deep water pump).

The vane pump that extracts water from the well is called a deep well pump. The long shaft deep well pump is a common type of well pump used in the well pump. It is mostly used in the well. The deep well pump consists of three parts: the uppermost is the electric motor, which is installed on the ground of the wellhead. The lower part of the water pipe and the drive shaft is the working part of the well pump, which is submerged below the well water surface. Due to the deep depth, the lift head is required to be large, and the lift range of the long shaft deep well pump is 50~1100 m. The deep well pump is generally segmented multi-stage Centrifugal pump. According to the structural characteristics of the deep well pump, proper use and timely troubleshooting are very important to ensure the safe operation of the deep well pump and prolong its service life.

When choosing a deep well pump, the first step is to confirm the depth of the well and the width of the well. Why do you want to confirm the width of the well? If you don't confirm the width, you are likely to buy a pump that cannot be put in.

Once again, we have to confirm the distance from the wellhead to the destination, so that we can calculate the lift of the deep well pump you actually need, and confirm the above points, then the model of the deep well pump should be confirmed.

Confirmed the model of the deep well pump, we must pay attention to the installation, the first step should be to add water to the deep well pump, because this series of deep well pumps are water-cooled, there is a water hole next to the motor, filled with water, connected If you have a good water pipe, you can put it in the well. Of course, the cable should be connected.

It is worth mentioning here that the deep well pump can't be placed at the bottom of the well because there may be fine sand at the bottom. If the motor is affected by the pump, the motor may be burnt and the impeller may wear.

Therefore, if we do not understand what to choose when using and using the deep well pump, it is best to give us a call and then confirm how to get it, how to deal with it. The above is how the basic deep well pump is used.

Shanghai Shenba Pump Co., Ltd. Professional deep well pump supplier Contact: 400-8886709